| The Product | Application | The beauty of the product | Area of Usage         Application     Nanoyo Titanium Dioxide (TiO2) is applied by spraying on to a designated surface, or any other surface such as walls, ceilings, curtains, cupboard, cushion and almost every surface, except glass which required full transparency. This is because the TiO2 comes in the form of white particles, thus it will form a semi-transparent film on glass surfaces, even though the film is a very thin layer.     Upon the application of Nanoyo Titanium Dioxide (TiO2) coating onto surfaces, it will form a thin layer of film on hard surfaces, however o soft surfaces like fabrics or carpets, the product will be penetrated inside these surfaces. The product will be dried off almost instantaneously. It will take 10-40 days to form a scratch proof hardness of 4H on the hand surfaces. However, the layer of our photo-catalyst coating will start working immediately after it has been applied. Light must be in existence for the coating to work at it’s full capacity. When contact with lights (normal fluorescent light or direct sunlight or even heat), it will trigger the photo-catalyst process of our product. When contacted with lights, the TiO2 will have a very strong decomposition power, decomposing anything that is organic in nature (micro-organisms) which comes into contact with or onto the treated area. Bacteria, viruses, funguses and many other airborne contaminants are organic in nature.       The picture below illustrates the effectiveness of the product under different lighting conditions:     Several issues have to be avoided:   Do not wash the surface which has been treated by Nanoyo with any detergent. Within the period of 14 days. Do not scratch the treated surface Do not polish the treated surface.             Copyrights (c) 2008,Nanoyo Corporation Sdn. Bhd. All rights reserved.